RCBS .270 Caliber Bullet Puller Collet
RCBS collet designed for their Standard Bullet Puller to safely remove jacketed bullets from .270 caliber brass cases without damage. Features standard 7/8-inch-14 threads for compatibility with most single-stage presses.
RCBS .270 Caliber Bullet Puller Collet
The RCBS Bullet Puller Collet is an essential tool for any reloader who needs to safely remove bullets from fired brass. Whether you're salvaging components or correcting a loading mistake, this collet makes the job straightforward and damage-free.
Key Features
- Caliber-Specific Design: Engineered specifically for .270 caliber cartridges
- Standard Threading: 7/8-inch-14 threads ensure compatibility with virtually all single-stage reloading presses
- Improved Design: Newly redesigned for easier operation and better reliability
- Gentle Extraction: Removes jacketed bullets without damaging brass or projectiles
How It Works
The operation is straightforward:
- Install the .270 collet in your press
- Insert your loaded cartridge into the press
- Lift the ram to position the cartridge
- Tighten the collet around the bullet
- Lower the ram to extract the bullet cleanly
Why You Need It
Accidents happen in the reloading process. A double charge, wrong powder, or simple miscalculation can ruin an otherwise good round. Rather than waste brass and bullets, the RCBS Bullet Puller Collet lets you safely recover your components and start over. It's an economical solution that pays for itself after just a few salvaged loads.
