RCBS X-Die Full Length Sizer Die 6.5 Creedmoor
Trim once, never again. RCBS X-Die Full Length Sizer features a patented mandrel design that eliminates repeated case trimming. Integrated expander ball and decapping pin. Made in USA.
RCBS X-Die Full Length Sizer Die for 6.5 Creedmoor
The End of Repetitive Case Trimming
The X-Die represents a genuine innovation in reloading technology. Its patented mandrel design accomplishes what conventional dies cannot: it controls case growth so effectively that you trim your cases once—and only once—at the beginning of their reloading life.
How It Works
The specially designed mandrel incorporates both an expander ball and decapping pin in a single, precisely engineered component. The mandrel's extremely close tolerance to the die's neck wall prevents the case neck from thickening as the case length is pushed back during sizing. This is the key to the X-Die's performance.
What to Expect
- Initial Setup: Trim cases .020 inch below maximum length to standardize them
- Subsequent Reloading: Cases will grow slightly at first, then stabilize well below maximum length
- Long-term Performance: No discernible loss of accuracy or case life, even after many reloading cycles
- Made in USA: Built to RCBS's exacting standards
Getting Started
If you're new to reloading 6.5 Creedmoor, consider the X-Die Full Length Set, which includes both the X-Die Sizer and a Standard Seater Die for a complete setup.
The X-Die isn't just a convenience—it's a time-saver that pays dividends over the life of your brass.
